Custom Bundle for PO 70116513

These vinyl labels from Bernard Engraving are geared toward labeling the components on bass boats.  Each label is 1/2" tall x 2 1/4" long.

Size: 3.5" x 1.8"

These little sling labels can prevent costly damage to boats being hauled out by travel lifts. They show the travel lift operator where to position the slings to avoid propeller shafts, saildrives, speedometer transducers, etc. Slings should also...

We hope you'll never need this label, but we think it's a smart thing to have near the radio in case the unthinkable happens.

Size: 3.5" x 1.75"

Finally a clear message to put in plain view of the marine toilet (head) in your boat.  If this label saves even one nasty disassembly/unclogging session, it will have paid for itself several times over.

Size: 4" x 2.25" Rectangular

For any boat connected to the pressurized water system at a dock. Once connected, a leak in the water system onboard can result in water damage, or even sinking. It is important to disconnect whenever leaving the boat unattended.

Size 1.5" x 3"

These vinyl labels from Bernard Engraving can be used on rope clutches or next to cleats to label control lines onboard. Each label is 1/2" tall x 2 1/4" long.